Specialized Roll X Bedienungsanleitung

1OWNER’S MANUAL

10EPIC FRAME GEOMETRY

11DERAILLEUR GUARD INSTALLATIONDerailleur Guard Installation (Q/R option):1. Install rear derailleur on derailleur hanger.2. Place rear wheel in frame

12LIGHTERFIRMEREPIC REAR SHOCK SETUPSTEP 1:Set sag:- See attached charts for starting air pressure.- After setting the pressure, push the rubber ring

13EPIC REAR SHOCK SETUP1. Set sag:• See the attached air chart for starting pressure. Use a high-pressure shock pump to add air.• Turn the Brain Fade

14The Specialized Epic Carbon frame utilizes advanced composite materials that require particular care during assembly, storage and riding. This insta

15Your Specialized frame does not require any Bottom Bracket or Head Tube pre-installation preparation. All surfaces are already prepared from the fac

16

17NOTE: Bearing and Bolt Kits are available only through your local Specialized dealer. To retain your warranty and for your safety, all maintenance s

18SBC LIMITED WARRANTYSpecialized Bicycle Components, Inc. (“Specialized”), a California corporation located at 15130 Concord Circle, Morgan Hill, Cal

19USEFUL PRODUCT LIFE CYCLEEvery Specialized bicycle and frameset has a useful product life cycle. The length of that useful product life cycle will

2

2015130 Concord CircleMorgan Hill, CA95037www.specialized.com© 2006 Specialized BicyclesPN# W2070130SPECIALIZED BICYCLE COMPONENTS15130 Concord Circle

3TABLE OF CONTENTSIntroduction...Fork Compatibility...

4Congratulations on your purchase and welcome to the finest line of suspension bikes available!About Off Road, Stunt, Downhill and FreeridingThis manu

5As activities such as racing, jumping, severe off road riding, and stunt riding are extremely dangerous, SAFETY should always be the first considerat

6Service and ModificationsTechnological advances have made bicycles and bicycle components more complex, and the pace of innovation is increasing. It

71. Main Frame2. Seatstay3. Chainstay4. Shock Link5. Main Pivot6. Dropout (Horst) Pivot7. Shock Link at Seatstay Pivot8. Shock Link at Frame Pivot9. L

8* TT length is the Horizontal Measurement from the center-line of the HT at the top of the HT to the center-line of the projected seat tube.** Stand

9* TT length is the Horizontal Measurement from the center-line of the HT at the top of the HT to the center-line of the projected seat tube.** Stand